中国人妻一区二区三区精品,国产精品一区乱码在线观看,亚洲理论在线a中文字幕,精品国产女主播在线观看

Your Position: Home > Support > FAQ

Oil Shortage Phenomenon and Replacement of Vacuum Oil Filter Oil Products

2019/8/1??????view:

  1. Check oil

  The oil level of the pump in operation must be located in the middle of the oil level glass window (6/4). If necessary, stop the pump and refuel according to the correct amount of oil. Excessive oil filling causes oil loss at high suction pressure.

  High fuel consumption generally indicates that the exhaust filter is blocked.

  When filling oil into the pump, the pump must be stopped.

  Check oil level at least once a day.

  2. Oil state

  Generally speaking, oil is clear and transparent. If the oil is dark, it should be replaced.

  If gases or liquids are dissolved in the oil, the limit pressure will deteriorate. Closing the inlet and opening the ballast valve to make the pump run for about 30 minutes can degasse the oil.

  When the pump is still at working temperature after stopping, some oil is discharged into beakers or similar containers through the discharging screw (6/5), which can be used to check the state of oil.

  warning

  According to the process involved, hazardous substances can spill over from pumps and oils. Corresponding safety measures should be taken.

  Comply with safety regulations.

  3. Change oil, change oil filter

  Tools used:

  Oil filter wrench (710 73 532)

  Always change oil when the pump is still at working temperature after shutdown.

  If the oil is in danger of polymerization of process gases in contact with it, the oil should be changed immediately after the pump is running.

  warning

  Pumps are hot in operation. Some surfaces can be as high as 80 (176).

  There is a risk of scald if touched.

  Turn off the drain plug (6/5) and let the used oil drain into the proper container.

  warning

  According to the process involved, hazardous substances can spill out of the pump or pump oil. Corresponding measures should be taken.

  Comply with safety regulations.

  Important Notes

  When handling used oil, please observe the relevant environmental regulations!

  When discharging oil, when the flow of oil decreases, screw the discharging screw on, start the pump for a short time (up to 10 seconds), and then stop the pump. Then screw down the oil drain plug to drain the remaining oil.

  Remove the oil filter (6/25), take a new oil filter, soak it with oil, and screw it on by hand.

  Re-install the drain plug (check the "O" ring and replace it with a new one if necessary).

  Remove the filling screw plug (6/6) and inject new oil into the lower edge of the oil level window, so that the pump can run for a short time, so as to flush the pump with the filling new oil. Then let the oil go.

  Use only the appropriate oil (see Section 1.8).

  warning

  According to the process involved, hazardous substances can spill over from pumps and oils. Corresponding measures should be taken. Comply with safety regulations.

  Watch out

  Do not install used seals; be sure to install new seals.

  Important Notes

  When handling used oil, please observe the relevant environmental regulations!


国产在线精品涩涩涩涩91| 新国产精品视频| 97精品在线| 大黑屄视频在线免费观看| 湿湿湿逼水无码| 伊人影视在线观看日韩区| 99热这里只有精品亚洲| 亚洲暴爽av天天爽日日碰| 99亚洲伊人久久精品影院| 国产精品一线二线三线区| av黄网页在线观看网站| 2022AV网在线观看| 欧美精品久久久天堂一区| 999精品视频| 亚洲欧美完美维纳斯日韩| 成人69式视频在线播放| 日本二本道欧美二区一区| 色综合色鬼无码久久88| 中文字幕亚洲综合小综合| 欧美激情精品久久久久精品| 亚洲日本在线观看视频露脸| 日产国产精品亚洲系列| 国产香蕉国产精品偷在线| 久久这里有精品中文字幕| 国产精品成熟老女人| 日产久久久久久综合精品| 91桃色一区二区亚洲熟女| 插屄的视频在线免费观看| 国产精品高朝呻吟久久av| 亚日韩精品人妻无码视频| 成人影院在线观看艹鸡吧| 国产 欧美 亚洲 精品| 91中文字幕有码在线观看| 国产成人综合欧美精品久久 | 少妇太爽了在线观看网站| 欧美人与性动交a欧美精品| 欧美 日韩 亚洲 高清| 奶69性爱美女在线视频| 少妇无码久久一区二区三区| 亚洲av大全一区二区三区| 国产精品无遮挡在线观看|